Brand NEW Welch Allyn 29372 Aerator Only for Welch Allyn Ear Wash System

Description

Welch Allyn 29372 Aerator Only
For WA Ear Wash System
New, in original package
This is a replacement part for the 29350 or 29360 Welch Allyn Ear Wash System.
Faucet Aerator Installation
The Welch Allyn Ear Wash System is designed for use on faucets where line pressure does not exceed 100 PSI or flow rate of 5.7 gallons/minute. If you suspect the line pressure or flow rate is greater, have it tested prior to use of the Ear Wash System or contact the Welch Allyn Technical Service Department.
1. Remove your current aerator from your faucet, including any original washers.You may need to use a pair of pliers to remove your aerator. If you still have difficulty in removing it, soak your current aerator in distilled vinegar for about twenty minutes and try again.NOTE: Failure to remove all parts of the aerator from the faucet will affect the Ear Wash System performance.
2. Ensure all snap aerator parts are intact and attach the assembly to your faucet by turning it counter-clockwise. If it does not fit, locate the appropriate adapter from the kit included with the unit. Attempt to match the adapter to your faucet and then attach the snap aerator. Verify the rubber washer on the snap aerator and adapter matches to the old washer on your faucet. If you need to use the threadless universal adapter (only available in certain regions), you may need to remove the inner rubber o-ring if it is too small for your faucet.
3. Once the snap aerator is attached to the faucet, the ear cleaning chamber is easily attached or removed. You can still use your sink normally when the Ear Wash System is not attached.